Muse Research Receptor manual v1.2 - Manual (Page 158)

12: Connecting Receptor to a Computer 158 Receptor Manual
6 Type two backslashes, followed by the name of your Receptor, followed by a single backslash and the
words “Hard Drive.”
For example, if your Receptor is named “Receptor-123456”, you would type:
\\Receptor-123456\Hard Drive
as shown below.
NOTE: To find the name of your Receptor, either:
•
From the front panel, 1) click the SETUP button, then 2) rotate the top display knob to select the Name parameter,
then 3) read the name from the bottom line of the LCD
•
From the graphical interface, 1) click the Setup tab in the View Bar, then 2) look at the field called “Receptor
Name” in the Network parameters box.
7 Click Next.
The next screen appears, asking you to name your Receptor.
8 Type any name you want.