Muse Research Receptor manual v1.2 - Manual (Page 55)

5: View Buttons in Depth 55 Receptor Manual
• Switch B & C - Switches the plugin and patch assigned to FX B with the one assigned to FX C.
Rotate the bottom display knob to choose between the three switch options. The switch option flashes indicating
you must press the bottom display knob to actually force the switch to occur.
FX: Get From
Rotate the top display knob to select the Get From parameter. Use the Get From parameter to copy the effect
(both the plugin and its current settings) from any other Receptor effects slot to the currently selected effects
slot.
0 1 G e t F r o m <
III III C H 0 2 : F X B : M u - P h a s e r
The Get From parameter takes the following form:
Ch <n>: FX <x >: <plugin name>
When you first select the Get From parameter, the Ch <n> field will be underlined and flashing. Rotate the
bottom display knob to select which Receptor channel contains the effect you wish to copy from (1-16, S1, S2,
or M), then press the bottom display knob to apply the selection, causing the
FX<x> field to be underlined and
flashing. Select which effect (FX A, FX B, or FX C) you wish to get from that channel. As you do this, the name
of the plugin currently assigned to that slot will be shown in the display. The
FX<x> value will flash until you
press the lower display knob, confirming that you’ve selected the plugin you wish to get.
The display will then ask you to confirm the copy operation.
0 1 A r e y o u s u r e ? <
III III Y e s
By default, the display shows
Yes
. Rotate the bottom display knob counter-clockwise to select
No
. Your choice
will flash until you press the bottom display knob to apply it.
MIX Button
Each of Receptor’s 16 instrument channels, 2 effects bus channels, and 1 master channel contains a set of
mix parameters that vary slightly depending on whether you’re viewing an instrument channel, an effects bus
channel, or the master channel.
This section discusses the parameters available when you press the MIX button on Receptor.
MIX: Volume
This parameter controls the channel’s volume. If Ch 1-16 is displayed, it controls the volume for the
corresponding instrument. If Effects Bus 1 (B1) or Effects Bus 2 (B2) is displayed, it controls the corresponding
effect return level. If Master is displayed, it control’s Receptor’s master overall signal level.
0 1 V o l u m e >
III III 1 0 5
Rotate the bottom display knob to set the volume level. Volume changes happen instantly, meaning you’re not
required to push the bottom display knob to apply the change.
SHORTCUT: When the Volume parameter is visible, you can reset it to its default level by pressing the bottom
display knob. The default level is 0dB, which provides neither volume gain nor volume attenuation.