Canon CR-1 MARK II - Manual (Page 73)

6. Main screen operations
-65-
Continued on the following page >>
6.8 QA
Take the steps below to adjust the images.
1 Select the image.
Click the thumbnail image.
2 Display the QA (Quality Assurance) screen.
Click the QA icon.
QA (Quality Assurance) screen
3 Set the parameters.
If the parameters have been saved, click Parameter Set , and click the name of the parameter set
from the list shown.
To set a new parameter, refer to the table below, and set it.
Parameter Operation
Contrast
Any contrast level from -100 to 100 can be set.
Drag the slider or click or .
Brightness
Any brightness level from -150 to 150 can be set.
Drag the slider or click or .
Gamma
Any gamma level from 0.01 to 3.00 can be set.
Drag the slider or click or .
Hue (R)
Any hue level from -100 to 100 can be set.
Drag the slider or click or .
Hue (G)
Hue (B)
Coordinate Hues
When this is checked, as soon as the value of one of the hues is changed,
the values of the other two hues will also be changed so that the sum total
of the values will be zero.
[Restore Defaults]
When this is clicked, the current parameters are set to the default values
for the retinal camera mode of the adjusted images.
[Set as Default]