OmniSistem SC 1216 - Manual (Page 10)

SC 1216 Plus Manual 2009‐10‐01
DELETING A STEP:
1) Enable program mode.
2) Select the chase that contains the step you wish to delete.
3) Press the TAP/DISPLAY button, the LCD shows the current step.
4) Press the BANK up/down button and scroll to the step you wish to select.
5) Press the AUTO/DEL button to delete the step. All LEDs will flash three times indicating the requested operation
has been performed.
DELETE A CHASE:
1) Press the button corresponding to the chase you wish to delete.
2) Press and hold down the AUTO/DEL button while holding down the chase button. All LEDs will flash three times
indicating the requested operation is complete.
DELETE ALL CHASES:
1) With the unit removed from all power sources, press and hold down the AUTO/DEL and BANK down arrow
button at the same time.
2) Return the unit to power sources and power on. All chases should be cleared.