OmniSistem SC 1216 - Manual (Page 11)

SC 1216 Plus Manual 2009‐10‐01
JOYSTICK/CHANNEL SELECTION
SETUP JOYSTICK:
1) Press and hold the PROGRAM button until the LED is lit.
2) Press and hold the MODE and FINE buttons at the same time, the assigned LED should light. If the reverse
LED lights, press MODE and FINE again to enter assign mode.
3) Use the BANK up/down keys to select the axis you wish to assign (Pan or Tilt).
4) Use the TAP/DISPLAY button to select 16 or 8 channel mode.
5) Press the button corresponding to the scanner you wish to assign.
6) While holding the mode button press the scene number corresponding to the slider controlling movement.
(Example: If pan is controlled by slider 4, press and hold the MODE button while tapping scene button 4)
7) Once you have selected the scene you wish to add, press the MIDI/REC button again. All LEDs will flash three
times indicating the new step has been inserted into the chase.
REVERSE JOYSTICK MOVEMENT/DMX CHANNEL:
1) Enable program mode.
2) Press and hold the MODE and FINE buttons at the same time to enter assign mode. Then press MODE and FINE
buttons again to enter reverse mode. The reverse LED should light indicating reverse mode is active.
3) Use the BANK up/down arrow buttons to change between the Pan and Tilt, the corresponding LED lights
indicating this selection.
4) Press the TAP/DISPLAY button to change between 8 channel and 16 channel mode.
5) Press the scanner button to select the scanner.
6) While holding the MODE button, press the corresponding scene button for the channel you wish to reverse.
7) Continue steps 3‐7 as needed. You may reverse a maximum of 48 channels for 12 scanners.
DELETE A SCANNER OF DMX CHANNELS:
1) Enable Assign or Reverse mode.
2) Tap the scanner button to select the scanner you wish to delete.
3) Press the MODE and AUTO/DEL buttons at the same time. All LEDs will flash three times indicating the
requested operation is complete.
CLEAR ALL DMX CHANNELS:
1) Turn the unit off via the power button only.
2) Press the MODE and AUTO/DEL buttons at the same time.
3) While holding the two buttons, turn the power back on to the unit. All LEDs will flash briefly indicating the
requested operation is complete.
DISPLAY DMX CHANNELS:
1) Press the MODE and FINE buttons at the same time enabling assign mode.
2) Press the MODE and FINE buttons again, lighting the reverse LED.
3) Press the scanner button set at the desired Pan and Tilt and the LCD will display the DMX values for Pan and Tilt.