Talkswitch TS-600 - Manual (Page 15)

W W W.T A L K S W I T C H . C O M 1 1
T S - 6 0 0 U S E R G U I D E
Call log — Dial from the call log. See the Call Log section for details on page 16.
Directory — Dial from the Phone Directory. See the Phone Directory section for
details on page 17.
One-touch speed dial — Press the desired “One Touch” speed dial key to call a
pre-programmed number.
Outside line access code is dialed automatically before any number with 7 or
more digits stored in the call log, directory, or memory buttons.
If you use the telephone keypad to dial a number, please dial the outside line
access code before the number.
You can switch a call between the handset, speakerphone or headset during the
call by either lifting the handset, pressing the speaker or headset buttons.
REDIALING CALLS
1. When you press the button, a list of previously dialed numbers is
displayed. The most recently dialed number is displayed on the top of list.
2. Press the
S button and the T button to move the highlighted line up and
down, respectively. Press the button when the desired number
is highlighted.
RECEIVING CALLS
When receiving calls, your phone will ring and the
display will show caller identity information if
you are subscribed to Caller ID service.
To answer an incoming call,
Lift the handset, or
Press the button or softkey, to answer the call in
speaker phone mode, or
Press to answer the call in headset mode.
You can mute the ringing for the incoming call by pressing the softkey.
Ringing volume can be adjusted or turned off by using the button
while the phone is idle or ringing.
VO LUM E
I G N O R E
A NSW E R SP E A K E R
D I A L / E NT E R
R E D I A L
12/09 03:00 PM
613-725-2980
John Smith
Answer Ignore