Cary Audio Design HD Surround Sound Processor Cinema 11a - Manual (Page 20)

CONTROLS AND DISPLAYS
19
REAR PANEL
LEFT
LEFT
RIGHT
RIGHT
ANALOG AUDIO INPUT ANALOG 7.1 INPUT 7.1 PREAMPLIFIER OUTPUT
7.1 PREAMPLIFIER OUTPUT RS 232
1
IR INPUT ZONE TRIGGERS
1 2 3
ZONE 2
AUDIO
OUT
FL SL CEN SBL
FR SR SW SBR
FL
FL
SL CEN SBL
SBL
FR
FR
SR
SR
SW
SW
SBR
SBR
AC POWER
[ ] 117V 50/60 Hz
[ ] 220V 50/60 Hz
Cinema 11a Surround Sound Processor CARY AUDIO DESIGN
1 2 3 4 5
1
3 2 4
6 7 8
5 6 7 8
DIGITAL INPUT AUTO
SETUP
MIC- IN
FM
75
AM LOOP
ANTENNA ZONE 2
DIGITAL
OUT
SL CEN
HDMI 1 INPUT HDMI 2 INPUT HDMI OUTPUT
2
12
1 2 3 4 5 6 7
8 9 10 11 13 14 15 16 17 18 19
1. ANALOG AUDIO IN (INPUT 1) XLR (L + R)
• Use these jacks for connection to balanced CD or DVD player analog output connections.
2. ANALOG AUDIO IN (INPUTS 2 THROUGH 8) RCA
• Use these jacks for connection to CD, DVD, TV, or VCR input options.
3. ANALOG AUDIO 7.1 INPUT
• By connecting a DVD audio player, SACD multi channel player, or other component that
has a multi-channel output, you can playback the analog audio with 5.1 channel or 7.1
channel outputs.
4. 2 ND ZONE ANALOG AUDIO OUT
• These jacks supply the analog stereo audio outputs to an external audio amplifier used to
power the speakers in the remote zone.
5. 7.1 PREAMPLIFIER OUTPUTS
• Use these jacks to connect to the main five- or seven-channel power amplifiers.
6. 7.1 PREAMPLIFIER OUTPUTS XLR
• Use these jacks to connect to the main five or seven channel power amplifiers.
7. AC INLET CONNECTOR
• Plug the power cord into this AC inlet and then into the power outlet on the wall.
8. DC TRIGGER OUTPUT TERMINALS
• Connect devices that need to be triggered by DC + 12V. (Screen, curtains, lights, etc.)
9. IR INPUT
• Use the 1 and zone 2 Ext remote jacks to connect external IR sensors. When the unit is
installed where it is not otherwise visible to the remote, connect an optional, external
sensor and the 1 (Main) jack will be activated. The Cinema 11a should be used for
connections to the power amplifiers for the main room speaker. The device connected to
the zone trigger will only be activated when the Multi-Zone system is turned on. Connect
it to the amplifier used to power the speakers in the second zone (Zone 2).