Section 6 programming overview, 1 security and data protection, 2 jumpstart autoprogramming – SilentKnight 5820XL User Manual
Page 80: Security and data protection, Jumpstart autoprogramming, Section 6.2). y, 2). y
LS10061-001SK-E
6-1
Section 6
Programming Overview
This section of the manual is intended to give you an overview of the programming process. Please read this
section of the manual carefully, especially if you are programming the control panel for the first time.
The JumpStart AutoProgramming feature automates many programming tasks and selects default options for the
system. You should run JumpStart at least once when you are installing the system. See Section 6.2 for details.
After you run JumpStart, you may need to do some additional programming depending on your installation.
Section 7 of this manual covers manual programmable options in detail.
Programming the panel can be thought of as a three part process. You must program:
•
System options. These are options that affect general operation of the panel (see Section 7.6 for details).
•
Options for input points and zones. These are primarily options that control the detection behavior of
devices (see Section 7.5 for details).
•
Options for output points and groups. This includes selecting characteristics for output groups and mapping
output circuits to output groups (see Section 7.4 for details).
6.1
Security and Data Protection
Communication Security - Level 1
Stored Data Security - Level 0
Physical Security - Level 1
Access Control Security - Level 1
6.2
JumpStart Autoprogramming
The JumpStart AutoProgramming feature allows for faster system setup. When you run JumpStart (immediately
after addressing SLC devices), the system scans devices on all SLC loops and determines device type (for
example, ionization smoke detector or heat sensor) and selects some system options based on the device type.
JumpStart AutoProgramming saves the installer from having to program options for each device. Depending on
the application, the installer may need to make some changes after JumpStart AutoProgramming completes.
See Section 6.2.3 for complete details about running JumpStart AutoProgramming.
IMPORTANT
JumpStart is intended to be run one time only, immediately after SLC devices have been addressed and connected.
JumpStart will reset all manually programmed options to default settings. Do not run JumpStart after you have
configured the system.