Solvline Eddy Series Ver 2.1a - Manual (Page 55)

Chapter 4. Integration
4.2 First-time Bootup
First of all, please make sure the power input you supply to the module is corresponding with the
Eddy model that you have. If an appropriate power input has been successfully supplied, Eddy will
power on and start booting. For those models that require power input through pins (this will leave
out DB9 models), you can notice that there are two Power In pins per serial port. It is a good practice
to connect both power pins to the power supply for more stability in operation.
Although there is no power LED to check the status, you can check by LEDs on the RJ45 Ethernet port.
LED status operation is described in
Chapter 3. Hardware Description . In models with DB9, you can
simply use a 5V DC power adaptor. In models with Pin Header, issue 3.3 ~ 5V power input.
An IP address is required to access Eddy’s web interface or telnet command-line configuration tool. By
factory default, Eddy is assigned a static IP address. After the initial connection, you can either
manually assign a different IP address or set Eddy to automatically get an IP address from a DHCP
server. While this depends on your network environment and policy, it is strongly recommended that
you assign Eddy with a unique static IP.
4-2