Solvline Eddy Series Ver 2.1a - Manual (Page 78)

Chapter 6. Configuration via Telnet
6.2 View commands
Commands related to View are as follows.
Table 6-1 def view commands
Commands Descriptions
def view Show all information about Eddy.
def view server Show network and device server’s settings.
def view port Show serial port settings.
def view gpio Show GPIO pin settings.
def help Show command list and help.
6.3 Network commands
Configure general network environment and network management.
Table 6-2 Network commands
Commands Default Descriptions
def mac
<Mac Address>
00:05:f4:00:20:
57
Register Eddy’s MAC address.
def line
[ip / dhcp]
Static IP IP obtaining method for Eddy’s network connection.
def ip
<IP Address>
192.168.0.223
Set the current IP address Eddy is assigned to.
When line type is Static IP, manually enter an
appropriate IP address.
When line type is DHCP, it is not editable. Instead,
current IP address is shown.
def mask
<Subnet mask>
255.255.255.0
Set the subnet mask Eddy is assigned to.
When line type is Static IP, manually enter an
appropriate subnet mask.
When line type is DHCP, it is not editable. Instead,
current subnet mask is shown.
def gateway
<Gateway
address> 192.168.0.1
Set the default gateway Eddy is assigned to.
When line type is DHCP, it is not editable. Instead,
current gateway address is shown.
def dns
<IP address>
168.126.63.1 Set the Domain Name Service IP address.
def portviewip
<IP address>
0.0.0.0
Configures IP of PC which Portview is installed
If IP is set to 0.0.0.0, NMS feature is disabled.
(Please refer to Portview User’s Manual for detailed
information.)
6-2