Solvline Eddy Series Ver 2.1a - Manual (Page 82)

Chapter 6. Configuration via Telnet
6-6
6.5 GPIO commands
Configure operation mode and value for each Programmable I/O pins.
(Only Eddy-CPU and Eddy-S1/Pin modules support this function.)
Table 6-4 GPIO commands
Commands Default Descriptions
def gpio <0~15> mode [in / out] Output Set current pin’s I/O mode.
def gpio <0~3> value [low / high] High
Set current pin’s output value. (This option
only applies to output mode pins)
6.6 Username/Password Commands
Configure username and password for Web/Telnet/FTP.
Table 6-5 User/Password configurations
Commands Default Descriptions
def username
<username>
eddy
Set username to use in Web, Telnet, or FTP.
16 Characters at maximum.
def password
<password>
99999999
Set password to use in Web, Telnet, or FTP.
16 Characters at maximum.
6.7 System Commands
Table 6-6 System Commands
Commands Descriptions
def default
Restore all settings to factory default. Requires reboot for changes
to take effect.
def save
Save current configuration settings. Requires reboot for changes
to take effect.
reboot Reboot Eddy.