TeeJet SmartPad II Lightshow User Guide - Manual (Page 7)

Page 7 of 11
Definition: Displays the heading error not determined message. This is the message presented to the
user during guidance if Heading Error was selected in setup as a display message and the vehicle
heading has not yet been determined.
Example: "heading_na" - displays ??? in the lightbar screen.
Keyword: xtrack
[OptParam1] The cross-track error (negative for left arrows).
[OptParam2] None
Definition: Displays the cross-track error message. This is the message presented to the user during
guidance if X-Track was selected in setup as a display message.
Example: "xtrack -2.3" - displays 2.3 with left arrows on either side in the lightbar screen.
Keyword: brightness
[OptParam1] Sets the LED brightness (1-100).
[OptParam2] Sets the Text display brightness (1-100).
Definition: Sets the lightbar LED and text display brightness.
Example: "brightness 50 70" - sets the LED brightness to 50% and the text display brightness to
70%.
Keyword: flash_on
[OptParam1] None
[OptParam2] None
Definition: Enables flashing lights (such as the guidance lights) on the lightbar. Note that this is the
default state when Light Show starts.
Example: "flash_on" - enables flashing lights.
Keyword: flash_off
[OptParam1] None
[OptParam2] None
Definition: Disables flashing lights (such as the guidance lights) on the lightbar. If these lights are tuned
on, they will not flash.
Example: "flash_off" - disables flashing lights.
Figure 11: xtrack