Toa FS-971 SERIES - Manual (Page 41)

41
9.5. Tables for Each Panel's Switch Settings
Note: Each figure of switch shows the factory-preset position.
9.5.1. Integrated Control Panel EP-0510
ON
OFF
1 2 3 4
0
5
0
6
0
7
0
8
0
ON
OFF
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
ON
SW1
ON
OFF
1 2 3 4 5 6 7 8
ON ON
OFF
1 2
1 2
1 2
1 2
SW1 setting function
Combination of 1 and 2
Line
Normal
Zone lamp
indication
Equipment that can
play main rack BGM
For inspection (Be sure to set these switches to OFF.)
Main rack system and all integrated remote
control units (Factory-preset position)
Main rack only
Be sure to set the switch to the OFF (Normal) position after checking line operation status.
All integrated remote control units
"Address 0" integrated remote control unit only
SW2, SW3 (Same construction)
1 2 3 4 5 6 7 8
ON ON
OFF
SW4
SW2 setting function
Possible Check On +8 minutes +4 minutes +2 minutes +1 minute +30 seconds
+15 seconds
All-zone broadcast interval
Impossible Normal Off
Emergency reset by
pressing key twice Normal/
check
ON
OFF
1 2 3 4
0
5
Not Repeated
6
0
7
0
8
0
SW3 setting function
Resumed 2 more repeats 1 more repeat Repeated +30 seconds +1 minute
Terminated 0
Warning Announce-
ment repeat mode
ON
OFF
1 2 3 4
0
5
0
6
0
7
0
8
0
SW4 setting function
On (Non-interlock) Evacuation Interlock +8 minutes +4 minutes +2 minutes +1 minute
Evacuation Announcement interval
Off (interlock) Warning Selected floor
Warning Announce-
ment interlock Warning/Evacuation
selection
Be sure to set the switch to the OFF (Normal) position.
Warning Announcement
repetition Nos. Warning Announce-
ment repetition
Warning Announcement repeat interval
+30 seconds
Manual Emergency
Broadcast interlock