Crestron electronic STX-1700CXP - Manual (Page 15)

Crestron STX-1700CXP 2-Way RF Wireless Touchpanel
Operations Guide – DOC. 6144 2-Way RF Wireless Touchpanel: STX-1700CXP • 11
SCREEN SETTINGS
- BRIGHTNESS
Brightness
From the SETUP MENU, press the Brightness button to open the SCREEN
SETTINGS – BRIGHTNESS screen. The UP and DOWN buttons increase and
decrease screen brightness, respectively. The area to the right of the buttons shows the
relative brightness from 0% to 100%.
Select the Return button to return to the SETUP MENU.
STARTUP PREFERENCE
Startup Preference
The Startup Preference option allows (when the touchpanel is off or in standby) the
display to come on or stay off when a “quick” pushbutton is pressed. From the SETUP
MENU, press the Startup Preferences button to open the STARTUP PREFERENCE
screen. In either case, the button signal will be sent to the RF gateway if the touchpanel
is in standby mode.
When pressed, the DISPLAY ON FROM HARDKEY button toggles between
ENABLED and DISABLED. With ENABLED selected, the display comes on when
one of the “quick” pushbuttons is pressed. With DISABLED selected, the display stays
off when a “quick” pushbutton is pressed (if touchpanel was off, it goes to standby).
The default is DISABLED.
Select the Return button to return to the SETUP MENU.
Power Management Timeout Settings
POWER MANAGEMENT
TIMEOUT SETTINGS
30 10
The Power Management feature is intended to conserve energy, and to extend the
service life of the battery. From the SETUP MENU, press the Power Management
button to display the POWER MANAGEMENT TIMEOUT SETTINGS screen. Use
the STANDBY and POWER DOWN UP and DOWN buttons to set the respective
timeouts from 0 through 120 minutes, where 0 disables the timeout. It adjusts in one-
minute increments from 1 to 10, in ten-minute increments from 20-120.
Use the Standby Now and Power Down Now buttons to immediately enter the
respective mode.
STANDBY timeout turns the display and backlight off when the touchpanel is
inactive for the specified time. When the touchpanel is reactivated, the last screen to
be displayed reappears. The specified time is displayed in minutes. The default
STANDBY timeout is 10 minutes.
POWER DOWN timeout turns off all power when the touchpanel is inactive for the
specified time. When the touchpanel is activated, the first page of the project
appears. The specified time is displayed in minutes. The default POWER DOWN
timeout is 30 minutes. It adjusts in one-minute increments from 1 to 10, in ten-
minute increments from 20-120.
NOTE: Power Down Timeout should be set low to maximize battery life. However,
Power Down Timeout should be set greater than Standby Timeout. Otherwise, the
Standby Timeout is meaningless.
NOTE: When the panel is powered down, it will take about 1.5 seconds to power up
and respond to a button press. There is no delay from Standby mode.
NOTE: This touchpanel does not include a built-in option to power up on the last
page viewed prior to power down. To power up on the last page viewed, you must
give the pages discrete join numbers and track them with SIMPL Windows logic.