Crestron electronic STX-1700CXP - Manual (Page 25)

Crestron STX-1700CXP 2-Way RF Wireless Touchpanel
Operations Guide – DOC. 6144 2-Way RF Wireless Touchpanel: STX-1700CXP • 21
Typical Connection Diagram when Uploading
NOTE: If the control system in use has a 4-pin network connector rather than a
modular (RJ11-type) NET connector, use an ST-CBL interface cable (sold
separately).
NOTE: To make a cable for either configuration, refer to the “Programming Cable
Specifications” diagram after these notes.
NOTE: An adapter such as a CN-RJ11 (sold separately) is required when using the
RJ11 cable.
NOTE: The RJ11 (part of ST-PK) and ST-CBL cables can also be found as part
numbers CNSP-585 and CNSP-586, respectively, in the Crestron cable database. The
database can be downloaded from the Downloads/Software Updates/Cables section
of the Crestron website (www.crestron.com).
NOTE: The procedure on the next page uses the ST-CBL.