Ambient conditions, Operating conditions, Notice – VACUUBRAND PC 301 User Manual

Page 10

Advertising
background image

Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully

the validity of this document with respect to his product. Manual-no.: 999147 / 17/06/2014

page 10 of 40

Comply with all

applicable and relevant safety requirements (regulations and

guidelines).

Implement the required actions and adopt suitable safety meas-

ures.

Ambient conditions

• Adopt suitable measures in case of differences from recommended conditions,

e.g., using the equipment outdoors, installation in higher altitudes, conductive

pollution or external condensation on the pump.

To the best of our knowledge the equipment is in compliance with the requirements

of the applicable EC-directives and harmonized standards (see ”Declaration of Con-

formity”) with regard to design, type and model. Directive EN 61010-1 gives in detail

the conditions under which the equipment can be operated safely (see also IP de-

gree of protection, „Technical data“).

Operating conditions

These pumps are not approved for operation in potentially explosive atmos-

pheres.

Do not operate the pumps in potentially explosive atmospheres.

Pumps without the ”

`

” mark on the rating plate are not approved for the

pumping of potentially explosive atmospheres. Do not pump potentially ex-

plosive atmospheres with those pumps.

Pumps bearing the ”

`

” mark on their rating plates are approved for the

pumping of potentially explosive atmospheres according to their classifica-

tion

II 3G IIC T3 X according to ATEX, but they are not approved for operation

in potentially explosive atmospheres (see section „

`

Important information:

Equipment marking (ATEX)“)

.

The pumps are

not suitable to pump any of the substances listed below.

Do not pump:

-

unstable substances

- substances which react explosively under

impact (mechanical stress)

without air

- substances which react explosively when being exposed to

elevated

temperatures without air,

- substances subject to

auto-ignition,

- substances which are

inflammable without air

-

explosive substances.

The pumps are

not approved for operation below ground. Do not operate the

pump

below ground.

Do not pump substances which may form deposits inside the pump. The pumps

are not suitable for pumping substances which may form deposits inside the

pump. Deposits and condensate in the pump may lead to increased tempera-

tures even to the point of exceeding the maximum permitted temperatures.

• Check the inlet and outlet of the pump, if there is a danger of forming

depos-

its inside the pump, e.g., in the pump chambers (the pump chamber is the part

between diaphragm and head cover. See section „Replacing diaphragms and

valves“). Inspect the pump chambers regularly and clean if necessary.

NOTICE

Advertising