Trouble-shooting and maintenance, Adjusting the cables – Sears 300 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLE-SHOOTING AND MAINTENANCE
Inspect and tighten all parts each time you use the SYSTEM 300. Replace all worn parts immediately (see
ORDERING REPLACEMENT PARTS on the back cover of this owner’s manual). The SYSTEM 300 can be
cleaned using a damp cloth and a mild detergent. Do not use solvents or abrasives.
ADJUSTING THE CABLES
If there is too much slack in the cables, they should
be tightened. Find the Eyebolt (55) in the Small
Weight (103). Loosen the 3/8" Nut (56). Thread the
Eyebolt further into the Small Weight, until there is no
slack in the cables. Finger tighten the 3/8” Nut (56)
against the Small Weight (103).
If the Eyebolt (55) is threaded into the Small Weight
(103) as far as possible, and there is still slack in the
cables, the Short Chain (52) should be adjusted.
Cpen the indicated Cable Clip (53) and slide the next
link of the Short Chain (52) onto the Cable Clip.
Adjust the Eyebolt as described above. When the
cables are properly adjusted, there should be no slack
in the cables, and the Small Weight (103) should be
resting on the Weight (46) below it.
21