Backwash cycle times, J.nn, C'uu – Sears Kenmore 625.348234 User Manual
Page 20: H=d5 h=25, J.nn c'uu, A. b. a. b
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 5
SERVICER'S TECH. INFORMATION
□
5B.
BACKWASH CYCLE TIMES
Factory set cycle times are: BACKWASH ... 25 min., FAST RINSE ... 5 min. Do the following to check for
correct cycle times.
NOTE:
NOTE:
Removing from electrical power {varies from 6 to 15
hours) resets timer to factory programming.
DISPLAY MUST SHOW TIME AND
DAY
1. Press and hold
a.
b.
a.
b.
entire
m i
PM
!
HCHG
< _______ ______
SUMOTUWE TH mSA
display comes on.
Press[^... 2:00 shows; mean
ing #2 cycle (not used) and 0
minutes.
If 2:00 does show, go to step 3.
If other than 2:00 (2:00 to 2:15,
press S until 2:00 shows.
Press[2]... 3:25 shows mean
ing #3 cycle (backwash) and 25
minutes.
If 3:25 does show, go to step 4.
If other than 3:25 (3:00 to 3:30),
press [
4
] until 3:25 shows.
j.nn
C'uu
i C
3=25
3=
n
I I
If the water supply has no iron and low sediment
content, a shorter backwash time could be adequate,
and will conserve water. On otherwater supplies, the
filter may require a backwash longer than 25
minutes.
4.
Press ^ . . . 4:05 shows;
a.
5.
6
.
meaning #4 cycle (fast rinse)
and 5 minutes.
If 4:05 does show, go to step
5.
If other than 4:05 (400 to 4:30),
press S] until 4:05 shows.
Press SI ... 18:88 shows.
Press El to return present
time and day.
H=D5
H=25
AM
i
PM
Z
RCHG
i
SUMOTUWETH FRSA
20