Program the timer – Sears Kenmore 625.348234 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 1
WATER FILTER START-UP
1D.
PROGRAM THE TIMER
FIG. 1
When the transformer is plugged into the electrical
outlet, 12:00 AM, SUnday began to flash in the time
display. Set the
time of day,
present
day of week,
and
days/time of backwash,
as follows.
1
.
SET TIME OF DAY
2
.
SET PRESENT DAY OF WEEK
a. Press the SET/CLEAR button 4 to set the
present day of the week in the display.
NOTE:
a.
Press the PRESENT TIME AND DAY
button
|T] once. The hour display continues to
flash.
b.
Press the SET/CLEAR button [4] until the pres
ent hour of the day shows in the display. Be sure
AM for morning hours, or PM for afternoon and
evening hours shows.
Press SET/CLEAR and quickly release to move the
day display 1 at a time. Or, hold the SET/CLEAR
button to move the day display ahead 2 days each
second.
b.
Press the PRESENT TIME AND DAY
button [j] again to steady the entire display.
Figure 2 shows the timer set at Tuesday.
NOTE:
Press SET/CLEAR and quickly release to move the
hourdisplay ahead 1 at a time to the correct hour. Or,
hold the SET/CLEAR button to move the display
ahead 2 hours each second, to the correct hour.
C.
Press button
|T] once to steady the hour
display, and minutes begin to flash. Repeat step
1 b to set the correct minutes.
d.
Press button
[T] again to steady the minute
display (day will begin flashing). Figure 2 shows
the timer set at 3:30 PM.
FIG. 2
PM
30D
TU
EXAMPLE: This drawing
shows the present time of
day at 3:30 PM, and the
present day on Tuesday.
Q PRESENT TIME AND DAY
G)
BACKWASH TIME
G)
BACKWASH DAY
G)
SET/CLEAR
C
rt ON/OFF VACATION
Z)
HOLD BACKWASH NOW
(continued)