5f. water flow through the filter valve, Service cycle, Backwash cycle – Sears Kenmore 625.348234 User Manual
Page 24: Fast rinse cycle, Servicer’s tech. information
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 5
SERVICER’S TECH. INFORMATION
5F. WATER FLOW THROUGH THE FILTER VALVE
VALVE OUTLET
(FILTERED WATER)
SERVICE CYCLE
VALVE INLET
(UNFILTERED WATER)
TOP
DISTRIBUTOR
MINERAL
TANK
POSITION
BOTTOM
DISTRIBUTOR
Hard, unfillered water enters the valve inlet port. Internal valve
porting routes the water down and out the top distributor, into the
mineral tank. The water is filtered as it passes through the
mineral bed, then enters the bottom distributor. Filtered water
tiows back into the valve and out the valve outlet, to the house
tittered water pipes.
ROTOR & DISC
VALVE
lUTLET
BACKWASH CYCLE
FLOW PLUG
^AIN
VALVE
INLET
TOP
DISTRIBUTOR
FAST RINSE CYCLE
ROTOR & DISC
POSITION SWITCH
BOTTOM
DISTRIBUTOR
POSITION
SWITCH
POSITION
SWITCH
%
DRAIN
'VALVE INLET
TOP
, DISTRIBUTC
BOTTOM
DISTRIBUTOR
Timer/switch action allows the motor to turn the rotor & disc
to place the valve in BACKWASH. Water is routed down and
out the bottom distributor, up through the bed, and out the top
distributor to the drain. The fast flow (controlled by a flow plug
in the drain fitting) flushes dirt, sediments, and iron deposits
to the drain.
During FAST RINSE, the rotor & disc is positioned so water
flow enters the mineral tank through the top distributor, and
exits through the bottom distributor, to the drain. The fast flow
of water downward through the mineral bed flushes any re
maining sediments to the drain. The mineral bed is packed and
prepared for return to service.
The solid state timer again energizes the motor to return the
valve to service. As the valve rotates, the position switch lever
drops to open the circuit. The valve remains positioned in ser
vice until the timer initiates the next regeneration.
24