Programming channel memory, Operating features – Sears 274.4392839 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Programming Channel Memory
'he channel memory is the list of
TV channel numbers your TV will
stop on when you press the
CHANNEL up or down button. You
can program any list of channels into
the channel memory.
The quickest way to program your
channel memor}' is to use the
AUTOPROGRAM innciion. If you
use \h& AUTOPROGRAM function,
your TV will automatically cycle
through all channels and place active
channels into the channel memory.
First follow the instructions to
autoprogram channels, and then add
or erase individual channels as
desired.
Notes:
• The AutoPrograra feature will place into
memory active TV channels that have a
valid signal at the time you autoprogram
your TV.
• An active channel may be missed
occasionally if its signal is very weak or if
the channel happens to be “off the air”
when the TV is autoprogrammed.
• An inactive channel may be included in the
channel memory if there happens to be
some sort of “noise” or “stray signal” on
the channel when the TV is
autoprogrammed.
• Signals from other components connected
to the INPUT jacks can not be
autoprogrammed. Channel 91 (which
accesses INPUT 1 jacks) was added to the
channel memory at the factory and will
remain in the channel memory until you
erase it. Channel 92 (INPUT 2) and
Channel 90 (S-VIDEO connector) can be
added to channel memory if desired.
• Only channels 1-99 can be stored in
channel memory.
Operating Features
AutoProgramming Channels into Channel Memory
1. Connect home antenna(s) or cable-
TV to your set.
3. Press either
h
- or - to begin
autoprogramming.
2. After you have turned on the TV
and adjusted the volume, repeatedly
10.P3 AM
1 6
press the SETUP button until
AUTOPROGRAM
is selected
(highlighted).
r
I
>
Cl
I
) A
r 1 ' I
t.______________
Set Alarm
Chan Label
Parental Ctrl Off
Chan Ctrl Normal
Autop'^ocrar’i
4. When the TV is finished cycling,
you can check to see which
channels are in memory by pressing
the CHANNEL up or down button.
Erasing/Adding Channels in Channel Memory
1
To erase or add a channel, press
SETUP
repeatedly until the CHAN
MEM
function is selected
(highlighted).
10?JAM
-
UT,
■
' №l9«
. •
3. Press + to add the channel to
memory, or press - to erase the
channel from memory.
2. Then select the desired channel
number by pressing CHANNEL up
or down (or the two corresponding
number buttons on the remote).
Adding Video Input Channels to Channel Memory
(with remote only)
If you have a video device connected to
the S-VIDEO or INPUT jacks on the
back of the TV, you can view its signal
either by directly selecting channel 90
(for S-VIDEO connector), channel 91
(for INPUT I jacks), or channel 92 (for
INPUT 2
jacks) with the number buttons
on the remote or by adding those
channels to the channel memory.
Adding channels 90, 91, and 92 to
channel memory allows access to the
video inputs at the TV by pressing the
CHANNEL
up and down buttons as
well as by using the remote control.
16