Sears 274.4392839 - Manual (Page 7)

Controlling Your TV
Remote Control Operation
Before attempting to operate your
remote control, install the batteries
as shown here.
Your remote control is designed to
be very rugged and will withstand a
considerable drop. If it receives an
extreme blow, the case is designed
to slightly separate at the seam
rather than fracture. If this happens,
simply squeeze the case where it
separated until it snaps back
together. The operation of the
remote will probably not be
alfected.
Only the remote buttons that are
used to control the TV are described
here. The rest of the buttons are
used to operate VCRs and cable-TV
boxes as described on pages 23 and
29.
Instaliing/Replacing Batteries
1. Turn the remote control face
down.
2. Press down on the ridged area of
the battery cover and slide it off.
3. Install four “AAA” batteries in the
battery compartment as shown.
Make sure you match the + end of
each battery to the + end of the
battery compartment.
4. Replace the cover and turn remote
over-face up.
Notes:
• The remote control produces an
invisible (infrared) beam that travels in
a straight line similar to the beam of a
flashlight. For this reason, when
operating the remote control, you must
point it directly at the front of the TV
without objects between that can block
the infrared light beam.
• Never place anything heavy on top of
the remote control or lay it upside-
down. This may accidentally depress
the buttons for a long time and
discharge the batteries.
• Replace the batteries when the TV fails
to respond to the remote control.
• If you programmed your remote to
control other components, you may
have to reprogram the code numbers
when you change the batteries. Try not
to press any buttons while changing
batteries.