CPG FIRELARM 2500 CPG #2561255 - Manual (Page 25)

E
D
C
B
5
A
4
CPG #2561255 F IRE L ARM 2500 Operating Manual
Order of characters
← key key →
! " # $ % & ' ( ) * + , - . / 0 1 2 3 4 5 6 7 8 9 : ; < = > ? ~
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z [ \ ] ^ _ '
a b c d e f g h i j k l m n o p q r s t u v w x y z { l } ← → (space)
4-3
To enter the configuration mode when no alarms are present, press

and enter the four digit
password. If no password has been entered , the default password is required (2402). If no touchpad is
pressed for 30 seconds while in configuration mode, the panel returns to normal standby condition. The
configuration mode cannot be entered if alarms are present. Zone labeling
SETUP ZONES?

To program zone descriptions

To exit configuration
To skip zone setup and go to password setup
To skip zone setup and go to ZDACT setup, if used
ENTER ZONE 1 DESCRIPTION?

To program the label for zone 1

To exit to SET UP ZONES? Screen
or To cycle forward or backward through zone configuration
screens
DESCRIPTION
or To select a character. Press and hold to scroll
quickly through the character set. See below for
order of characters

To set the selected letter and advance the cursor

To save the zone description or cancel changes
SAVE? (Y/N/BACK)

To save changes and advance to next zone

To keep previous setting and advance to next zone
To modify the zone description
ENTER ZONE 2 DESCRIPTION?
Similar to ENTER ZONE 1 DESCRIPTION above.
ENTER ZONE 3 DESCRIPTION?
Similar to ENTER ZONE 1 DESCRIPTION above.
ENTER ZONE 4 DESCRIPTION?
Similar to ENTER ZONE 1 DESCRIPTION above.