CPG FIRELARM 2500 CPG #2561255 - Manual (Page 43)

E
CPG #2561255 F IRE L ARM 2500 Operating Manual
E-1
Appendix E. Quick Reference Operating
Instructions
FireLarm 2500
Normal Standby Green AC indicator on. All other indicators off.
Alarm Conditions Red zone indicator on. Audible/visual signaling indicator
operating
To Silence Alarm Do not silence alarm until it has been determined that an
emergency situation does not exist (panel must be reset to
silence waterflow alarms). Open cover and press . This will
also cause the bell trouble indicator to flash.
To Reset an Alarm After condition that caused alarm has been corrected, press
.
Trouble Conditions Yellow SYSTEM TROUBLE indicator and buzzer on. Yellow
indicator for specific trouble on (battery, zone, trouble, etc.)`
Supervisory Condition Yellow SYSTEM TROUBLE indicator and buzzer on. Yellow
SUPERVISORY indicator on (valve closed, low air, low
temperature, etc.)
To Silence Trouble
Devices Open cover and press . The panel automatically restores
to normal when the trouble condition has been corrected.
Some trouble conditions require pressing  for restoration.
Note: The problem must be corrected as soon as possible as
this may make system inoperative. Contact your service
organization if necessary.
To Test Alarm Notify building occupants (if a fire department or other
monitoring agency, such as a Central Station alarm company,
monitors alarms, they must also be notified). Open cover,
press and hold for 2 seconds.
This system should be thoroughly inspected on a regular basis in accordance
with the NFPA-72 National Fire Alarm Code and the authority having
jurisdiction. Contact the agency listed below for this service.
For Service, Call
Name:
Address:
Telephone:
INSTALLER: FRAME THIS SHEET AND PLACE ADJACENT TO CONTROL PANEL
CPG Signals
2519 4
th Ave., P.O. Box 590, Moline, IL 61265
(800) 577-5758 / (309) 762-0731 / FAX (309) 762-8215
www.cpglifesafety.com