Microphone mixing, Recommended microphones, To change the delay time of echo – Aiwa CX-NA31 User Manual

Page 18: To record microphone sound mixed with source sound, When not using the microphones, Vocal fader/multiplex functions, Vocal fader, Auto vocal fader, Multiplex, Auto multiplex

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

I

MICROPHONE MIXING

I

Recommended microphones

The use of unidirectional type microphones is recommended to

prevent howling. Contact your local Aiwa dealer for details.

3

,

4,5

4

Two microphones (not supplied) can be connected to this unit,
allowing you to sing along to music sources.

Use microphones with mini plugs (03.5 mm. Vs inch).

1 Connect your microphones to the MIC 1 and MIC

2 jacks.

MIC1

2 Press one of the function buttons to seiect the

source to be mixed, and play the source.

3 Adjust the volume and tone of the source.

4 Press the MIC button and turn the VOLUME

control

within

4

seconds

to

adjust

the

microphone voiume.

The microphone volume can be selected from 1 to MAX (7)

or OFF (cancel).
The volume of both microphones is adjusted simultaneously.

5 Press the ECHO button and turn the VOLUME

controi within 4 seconds to adjust the echo ievei.

The echo level can be selected from 1 to MAX (7) or OFF

(cancel).

To change the delay time of echo

Hold down the ECHO button during the echo is on.
“L” (Long) and “M” (Middle) are displayed alternately. At the

desired position, release the button.

To record microphone sound mixed with source sound

Follow the procedure for recording from the sound source (see

page 13).
The SYNCHRO DUBBING button cannot be used for mixing
recording.

When not using the microphones

Set the microphone volume and echo level to OFF and remove
the microphones from the MIC jacks.

• When the MIC or ECHO level is changed, the DSP surround

mode is automatically Canceled.

• If microphones are held too near the speakers, a howling sound

may be produced, in this case, hold the microphones away
from the speakers, or decrease the microphone volume.

• If sound through the microphones are extremely loud, it may

be distorted. In this case, decrease the microphone volume.

• When the function is changed, the microphone volume and the

echo volume are set to off.

17

ENGLISH

VOCAL FADER/MULTIPLEX FUNCTIONS

This unit can use discs or tapes as Karaoke sources.

Use the vocal fader function for ordinary discs or tapes.
Use the multiplex function for multi audio discs or tapes.

Press the KARAOKE button repeatedly to select the vocal

fader or multiplex function.

Each time the KARAOKE button is pressed, one of these
functions is selected cyclically.

(D

.......->7tJ

©

® Vocal Fader

The singer’s voice becomes softer than the accompaniment.

@ Auto Vocal Fader

The singer’s voice becomes softer only while there is audio

input through microphones.

©Multiplex

The sound on the left channel is heard from both speakers,
and the sound on the right channel is muted.
To hear the sound on the right channel, see below.

® Auto Multiplex

The sound on the left channel is heard from both speakers,
and the sound on the right channel is muted only while there
is audio input through microphones.
To hear the sound on the right channel, see below.

® Cancel

To change the audible channel in Multiplex function

When Multiplex is selected, ”MPX-L“ is displayed for 3 seconds
and changes to the selected function name. After the selected
function name is displayed, keep pressing the KARAOKE button
until “MPX-R” is displayed.
To return to the initial setting, select MPX-L.
When the power is turned off, MPX-L is restored.

To change the time lag setting in Auto Vocal Fader or
Auto Multiplex function

The muted original singer’s voice can be turned faster to the

normal level.
When Auto Vocal Fader or Auto Multiplex is selected, “A-VF” or
“A-MPX” is displayed for 3 seconds and changes to the selected

function name. After the selected function name is displayed,
keep pressing the KARAOKE button until “FAST” is displayed.
To

return

to

the initial setting,

select SLOW.

When the power is turned off, SLOW is restored.

• The Karaoke functions may not operate correctiy with the

following kinds of CDs or tapes.
- Those with monaural sound
- Those recorded with strong echoes
- Those with the vocal part recorded on the right or left side of

the sound width

•While the Karaoke function is on, the sound is output as

monaural.

• When the function is changed, the Karaoke function is canceled.

Advertising