Aiwa CX-NA31 - Manual (Page 20)

SEHING THE CLOCK SETTING THE TIMER
Press the CLOCK button while pressing the
SHIFT button on the remote control, and press
the
I I SET button within 4 seconds.
.. v'' .'../.-r......
i
i
i :• ; i i i
i ! ! : •si'.J LJ
2 Press the ◄◄ DOWN or ►► UP button to
designate the hour, and press the I I SET button.
The hour stops flashing and the minute starts flashing.
3 Press the ◄◄ DOWN or ►► UP button to
designate the minute, and press the I I SET
button.
The minute stops flashing on the display and the clock starts
from 00 seconds.
To display the current time
Press the CLOCK button while pressing the SHIFT button on
the remote control. The time is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press the CLOCK button while pressing the SHIFT button on
the remote control and then press the ■ button within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
Use the remote control.
1 Press the TIMER button while pressing the SHIFT
button once to display ©, and press the I I SET
button within 4 seconds.
© is displayed, and the hour flashes.
0
■ ^ \ / i
65
If you press the II SET button after 4 seconds, another
operation may start.
2 Designate the hour of the timer-on time by
pressing the ◄◄ DOWN or ►► UP button, and
press the II SET button. Repeat to designate the
minute of the timer-on time.
After you designate the timer-on time, one of the source name
flashes on the display for 4 seconds.
3 Within 4 seconds, press the FUNCTiON button
repeatediy to seiect a source.
The selected source name flashes for 4 seconds.
• If this step is not completed within 4 seconds, repeat from
step 1.
• If the TUNER button is pressed, the band cannot be selected
fn this step.
4 Within 4 seconds, seiect the duration for the
timer-activated period with the ◄◄ DOWN or I
UP button.
S
■■■■’ f""i
L"
TTTT' ^
T 6 .r 8 ■
:ij
19
ENGLISH