Finishing, Nailing tab installation – Continental BCDV48N User Manual

Page 19

Advertising
background image

W415-0327 / B / 12.07.07

19

NAILING
TAB

FIGURE 39

1) Attach the nailing tabs to the corner posts using the 2
sheet metal screws supplied. Secure through the
centre of the top and bottom slots in the nailing
tab and then through the existing holes in the
corner posts.

If there are no existing holes, follow these
instructions:

Position the nailing tab so that the front face
is offset with the front edge of the corner post
(approx. ½"). Centre the nailing tab vertically
on the corner post.
Figure 40 a.

Drill through the centre of the top and bottom
slots in the nailing tab. Secure using the two
sheet metal screws supplied. This allows the
nailing tab to slide back and forth for desired
framing. Figure 40 b.

2) To determine the fi nal location of the nailing tab
you must fi rst determine the thickness of your fi nishing
material (i.e. drywall). This will determine the dimension from
the front edge of the corner post to the nailing tab. Once the nailing
tab is in the desired location, drill through the centre hole of the nailing
tab. Secure with a sheet metal screw*. Figure 40 c.

* Additional set screws may be installed.

NAILING TAB INSTALLATION

FIGURES 40a-c

TOP

SLOT

FINISHING
MATERIAL

CORNER

POST

NAILING

TAB

B

CENTRE

HOLE

A

C

FINISHING

PHAZER

TM

logs and glowing embers, exclusive to Continental® Fire-

places, provide a unique and realistic glowing effect that is different
in every installation. Take the time to carefully position the glowing
embers for a maximum glowing effect. Log colours

may vary. During

the initial use of the fi replace, the colours will become more uniform as
colour pigments burn in during the heat activated curing process.

1. Center the rear log (#1) behind the rear burner and onto the log
support.

2. Place log#2 and log#3 onto the locating pins. The logs should sit
fl at on the burner.

3. Place the locating hole on the underside of log#4 onto the locating
pin on top of log#3. The notch at the opposite end of log#4 sits on
the third grate post in from the right.

LOG PLACEMENT / GLOWING EMBERS

FIGURES 41a-h

#1

#2

#3

#4

#5

Advertising
This manual is related to the following products: