Aiwa NSX-MT725 - Manual (Page 23)

RECORDING
BASIC RECORDING
This section expiains how to record from the tuner, CD piayer, or
externai equipment.
'•/OREC/
REC MUTE
Preparation
• Use Type I (normal) and Type II (high/CrOa) tapes for recording.
• Set the tape to the point where recording wiii start.
1 Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
-±PUSH
EJECT
To stop recording,
press ■ .
To pause recording,
press
II.
(Applicabie when the source is
TUNER, VIDEO/AUX or MD) To resume recording, press it again.
To start recording with the remote control
First press
#/0 REC/REC MUTE,
and then press I
2 seconds.
► /◄ ► within
Sound adjustment during recording
The VOLUME controi has no effect on recording, it oniy sets the
level feeding the speakers and headphones. Remember, however,
recording takes on the BEAT, AUTO SPICE/FILL iN, SPiCE A/B
functions, as weil as on the BBE functien.
INSERTING BLANK SPACES
insertion of 4-second biank spaces enabies you to activate the
Music Sensor function. (Applicable when the source is TUNER/
BAND, ViDEO/AUX or MD.)
1 Press • REC/REC MUTE during recording or while in
recording pause mode.
ln=tH on the display flashes for 4 seconds and 4-second blank
space is made. Then, the deck enters the recording pause
mode.
2 Press II to resume recording.
To insert a blank space of less than 4 seconds,
press •
REC/REC MUTE
again while
l;l=t«i
is flashing.
To insert blank spaces of more than 4 seconds,
after the deck
enters recording pause mode, press #
REC/REC MUTE
again.
Each time the button is pressed, a 4-second blank space is added.
2 Press REV MODE to select the reverse mode.
To record on one side oniy, seiect
1.
To record on both sides, select TD or CZ).
3 Press function (TUNER/BAND, VIDEO/AUX, CD or
MD) and prepare the source to be recorded.
To record from a CD.
press
CD
and load the disc(s).
To record from a radio broadcast,
press
TUNER/BAND
and
tune in to a station.
To record from a connected source,
press
VIDEO/AUX
or
MD.
4 Press # REC/REC MUTE to start recording.
When recording from a connected source, start playback of
the source.
• ! ! !.„! ! ii ...,S •
IsTsTil
When the selected function is CD, playback and recording
start simultaneously.
“Can’t REC” is displayed
if
you attempt to record on a tape with
the plastic tabs broken off.
To erase a recording
Make sure the microphone is not connected to this unit. Set the
microphone volume and the echo level to OFF (see page 28).
Also, check to make sure that BEAT and AUTO SPICE are
switched off (page 11).
1
Insert the tape to be erased into deck 2 and press
TAPE/
DECK 1/2
to display “TP 2”.
2
Set the tape to the point where the erasure is to be started.
3 Set the reverse mode by pressing
REV MODE.
4
Press 9
REC/REC MUTE
to start the erasure.
22
ENGLISH