Setting the sleep timer, 1 press clock, 1 press sleep – Aiwa NSX-MT725 User Manual
Page 30: Sleef, 3 press enter or ii, To restore an original clock setting, To switch to the 24-hour standard, If the clock display flashes, To cancel the sleep timer, Setting the sleep timer (3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CLOCK AND TIMER
SEHING THE CLOC
SETTING THE SLEEP TIMER
1
3
The clock is displayed. (The between the hours and minutes
flashes.) When the power cord is piugged into an AC outlet
for the first time after purchase or when the clock setting is
canceled due to a power failure, the entire ciock display
flashes.
1
Press CLOCK.
The unit can be turned off automatically at a specified time.
Use the remote control.
1
Press SLEEP.
.... ,SLEEF=
f l n i 2 ; ; 0 ©
2
Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
Turning
MULTI JOG
changes both the hour and the minute.
◄ ◄ or ► ► is aiso avaiiable instead of
MULTI JOG.
Holding
these buttons down will vary the time rapidly.
3 Press ENTER or
II.
The clock starts from 00 seconds.
To restore an original clock setting
Press
CLOCK
before completing step 3 to restore the previous
time setting. This cancels any new setting.
To view the clock when another display is in the display
Press
CLOCK.
The time is displayed for 4 seconds and then the
original display reappears. However, the clock cannot be
displayed during recording.
To switch to the 24-hour standard
Press the
CLOCK
and then press ■ within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
2
Within 4 seconds, turn MULTI JOG to specify the
time until the power is turned off.
The time changes between 5 and 240 minutes in 5-minute
steps.
and ► ► are also available instead of
MULTI JOG.
Specified time
To check the time remaining until the power is turned off
Press
SLEEP
once. The remaining time is displayed for 4
seconds.
To cancel the sleep timer
Press
SLEEP
twice so that “SLEEP oFF” appears on the display.
If the power-economizing mode (page 8) is on, all the display
lights turn off when the power is turned off. To view the clock,
press
CLOCK
so that the time is displayed for 4 seconds.
30
ENGLISH