Arrow Storage Products CM1014 - Manual (Page 14)

Step 1
• Parts Needed For •
Floor Frame Assemblies
• 8934 Ramp(1)
• 9367 Front Floor Frame (2)
• 8936 Rear Floor Frame (2)
• 10387 Side Floor Frame (4)
The front floor frame is made up of
three pieces. The side floor frames
and the rear floor frame are made up
of two pieces. The holes in these
pieces will align when the pieces are
positioned with correct amount of
overlap. The illustrations below show
the properoverall length forthe sides,
rear and front. Proceed as follows:
1
Place the front floor frames as
shown. Center the ramp, with drain
holes facing outside, on top ofthe two
front floor frames. Join the frames by
inserting eight screws.
2
Overlap the side floorframes and
the rear floor frames as shown. The
holes in these pieces will align when
the pieces are positioned with cor­
rect amount of overlap. See the illus­
trations below for the proper overall
length ofthesideand rearfloorframes.
Join the frames by inserting four/five
bolts into each frame set as shown.
3 Double check the length of
and set these pieces aside for
use.
Front Floor
Frame Assembly
119 3/8" 3.0m
’DRAIN HOLES FACE.
OUTSIDE
Side Floor Frame 158 5/8" 4.0m
Rear Floor Frame 119 3/8"
3.0m
8936
14