Arrow Storage Products CM1014 - Manual (Page 19)

step
6
Parts Needed For
Corners
• 6515 Wall Panel (2)
• 9373 Front Wall Panel (2)
• 6020 Corner Panel (4)
NOTE
The remainder of the building assembly
requires many hours and more than one
person. Do not continue beyond this point
if you do not have enough time to com­
plete the assembly today. A partially
assembled building can be severely
damaged by light winds.
Each screw and bolt in the wall re­
quires a washer.
1
Position a corner panel at the
corner of the floor frame as shown.
The widest part of each corner panel
must be placed along the side of the
building for all four corners. Fasten
the corner panel to the floor frame
with one screw.
Support the corner panel with a step
ladder until a wall panel is attached.
2
Attach the front wall panels to the
front corner panels, as shown. A small
gapwill exist between front wall panel
and ramp.
3
Attach the wall panels to the rear
corner panels, as shown.
NOTE
Be careful to install the correct
panel in each position as shown
Narrow
Side
4
Double-check the part numbers of
the wall panels, before proceeding.
The floor frame must be square
and level or holes will not align.
Washer
Panels rest on »V"
frame as shown
19