Aiwa CX-NMT240 - Manual (Page 11)

TAPE PLAYBACK
BASIC OPERATION
■ MULTI JOG
■áLPUSH
EJECT
Deck 2
This unit is designed for optimal playback of Type I
(normal) tapes.
1 Press TAPE and press
the cassette holder.
± PUSH EJECT to open
APUSH
EJECT
To select a playing deck
When tapes are loaded in both decks, press TAPE first to select
a deck.
The selected deck number is displayed.
To stop play, press ■.
To pause play (deck 2 only), press II. To resume play, press
again.
To fast forward or rewind, press ◄◄ or ►►. Then press ■
to stop the tape.
To start play when the power is off (Direct Play Function)
Press TAPE. The power is turned on and play of the inserted
tape begins.
To set the tape counter to 0000
Press ■ CLEAR in stop mode.
The counter is also set to 0000 when the cassette holder is
opened.
When tapes are loaded in both decks
After playback on deck 1 finishes, the tape in the deck 2 will start
to play without interruption and will stop at the end of the tape.
(Continuous play)
Type II (High position) tapes can also be played back in this
unit. When playing back a Type II tape, turn WlULTl JOG to display
“SOFT” in the display. This will set the optimum playback sound
for Type II tapes. However, “SOFT” playback will be canceled if
any graphic equalizer is selected (page 9), the unit is switched
to a different audio source, the cassette holder is open, or when
the power is turned off.
Z
O
lU
u
u
a
w
<
K
z
o
<
a
>■
111
A
<
t-
Insert a tape with the exposed side down. Push the cassette
holder to close.
2 Press ► to start play.
Only the side facing out from the unit can be played back.
----- y,--.
T ' ; i
Selected deck
I
number
rO,
! ; : ; : I
ENGLISH
1 1