Aiwa CX-NMT240 - Manual (Page 17)

PROGRAMME
3,7,
8,9
4,5
In the programmed edit recording function the tracks can be
programmed while checking the remaining time on each side of
the tape.
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded on from the beginning of
either side.
1 Insert the tape into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
2 Press CD and load the disc(s).
3 Press CD EDIT/CHECK twice on the remote
control.
“EDIT” and “PRGM” are displayed.
• When “Al” is displayed, press CD EDIT/CHECK again.
4 Press numbered buttons on the remote control
to designate the tape length.
10 to 99 minutes can be specified.
• The ◄◄, ►► or MULTI JOG are also available to designate
the tape length.
Tape side A (front side)
nOCK nor- C...AS&iC
i ' (
Tape length Maximum recording
time for side A
5 Press DISC DIRECT PLAY 1-3 to select a disc.
Then, press numbered buttons 0-9 and +10 on
the remote control to program a track.
Example: To select the 10th track of disc 2, press DISC
DIRECT PLAY 2, then press +10 and 0.
Selected track number
I lj_ _U 11
Programmed tracks
j
Program number Remaining time
on side A
Repeat step 5 for the rest of the tracks for side
A.
A track whose playing time is longer than the remaining time
cannot be programmed.
Press CD EDIT/CHECK on the remote control to
select side B and program the tracks for side B.
After confirming “B” on the display, repeat step 5.
J
i : i-i
'■ i !■ i
i ; ■.
• '■
V ^ ~
tS?;
Tape side B (reverse side)
8 Press CD EDIT/CHECK on the remote control to
select side A and press • REC/REC MUTE to
start recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When the last track programmed for side A is finished,
deck 2 enters the recording stop mode. After entering the
recording stop mode, go to step 9.
9 Press CD EDIT/CHECK on the remote control for
recording of the second side.
“B” is displayed.
iOTurn over the tape in deck 2 and press • REC/
REC MUTE to start recording.
Recording starts.
To stop recording
Press ■. Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK on the remote control
to select side A or B, and press ◄◄ or ►► repeatedly.
Programmed
track numbers Track number
I
Disc number
- ___ ____ ____ _____ _____ = V - (—
- - ■-:T h i @ L
Tape side Program number
To change the program of each side
Press CD EDIT/CHECK on the remote control to select side A
or B, and press ■ CLEAR to clear the program on the selected
side. Then program tracks again.
To clear the edit program
Press ■ CLEAR twice so that “EDIT” disappears on the display.
' Up to 30 tracks can be programmed from any of the inserted
discs.
' “FULL’ is displayed if you attempt to program more than 30
tracks.
O
z
5
K
o
o
u
oc
ENGLISH
1 7