Aiwa CX-NMT240 - Manual (Page 12)

CD PLAYING
LOADING DISCS
Press CD, then press ± OPEN/CLOSE to open the
disc compartment. Load disc(s) with the iabel side
up.
To play one or two discs, place the discs on tray 1 and 2.
To olav three discs, press DISC CHANGE to rotate the trays
after placing two discs. Place the third disc on tray 3.
Close the disc compartment by pressing ±
OPEN/CLOSE.
Tray
Tray number of the
disc to be played
___________ J
a
i r'i
i I i !■ 1 ; .
" "i .....i-1.'." !.J'
I
Total number of tracks
PLAYING DISCS
Load discs.
To play all discs in the disc compartment, press I
Play begins with the disc on tray 1.
___ ; 1 ■ ■■ ■ ■ . -
' V. \—
--- --------------
_
Totai playing time
Number of track being played Elapsed playing time
To play one disc only, press DISC DIRECT PLAY 1-3.
The selected disc is played once.
To stop play, press ■.
To pause play, press II. To resume play, press again.
To search for a particular point during playback, keep
or ►► pressed and release it at the desired point.
To skip to the beginning of a track during playback, press
◄◄ or ►► repeatedly or turn MULTI JOG.
To remove discs, press ± OPEN/CLOSE.
To start play when the power is off (Direct Play Function)
Press CD. The power is turned on and play of the loaded disc(s)
begins.
When
± OPEN/CLOSE is pressed, the power is also turned on
and the disc compartment is opened.
To check the remaining time
During play, press CD EDIT/CHECK on the remote control. The
amount of time remaining until all tracks finish playing is
displayed. To restore the playing time display, repeat the above.
Selecting a track with the remote control
1 Press DISC DIRECT PLAY, then press numbered buttons 1­
3 within 3 seconds to select a disc.
2 Press numbered buttons 0-9 and +10 to select a track.
Example:
To select the 25th track, press +10, +10 and 5.
To select the 10th track, press +10 and 0.
The selected track starts to play and continues to the end of
that disc.
Replacing discs during play
While one disc is playing, the other discs can be replaced without
interrupting play.
1 Press DISC CHANGE.
2 Remove the discs and replace with other discs.
3 Press A OPEN/CLOSE to close the disc compartment.
• When loading an 8-cm (3-inch) disc, put it onto the inner circle
of the tray.
• Do not place more than one compact disc on one disc tray.
• Do not tilt the unit with discs loaded. Doing so may cause
malfunctions.
• Do not use irregular shape CDs (example; heart-shaped,
octagonal ones). It may result in malfunctions.
12
ENGLISH