Akai Multi Video Processor RMD-V3104U - Manual (Page 23)

MVP MANUAL
(2) To perform coarse adjustments of the picture frame [&P2, &Q2 commands]
Input: &P2d2hih2ha, &Q2d2hih2ha (3
Explanation: &P2 command: Horizontal direction
&Q2 command: Vertical direction
d
2
: Screen position (1 to 2)
hih
2
ha : crew start position data (&P2:000 to 1C5, &Q2:000 to 20A)
Although the data is an absolute value, the relative value with the current data can also be speci­
fied.
•Input: &P2d2 3^J), &P2d2 3-3
&Q2d2 3^, &Q2d2 3-3
d
2
: Screen position (1 to 2)
+ : Left direction (horizontal), and up direction (vertical) looking at the screen.
- : Right direction (horizontal), and down direction (vertical) looking at the screen.
3 : Adjustment mode end
&P2d2 3
+-+-3
&P2d2 3
RES 3
: Input the current value at
: RES is the initial value
&P2d2 3
1003 : Input the value after checking the current value
The screen start position is the position of the screen actually displayed in respect to the magni­
fied image.
Position displayed on the screen
Magnified image
• This command is used for the coarse adjustment of the picture frame when the adjustment range
is exceeded with the &G command.
• The data shift amount is greater than the &G command.
• Execute &W^I1 to initialize. (Refer to &W command.)
Note: For details of the picture frame adjustment procedure, refer to "Picture Frame Adjustment Procedure".
Note: To end the adjustment, be sure to input
3 ■
If
3
is not input, commands input thereafter may not be executed.
Note: If the power is cut in this state, the new screen start position data will not be saved. To save the data,
execute &W1
3.
(Refer to the & W command.)
149