Baud rate switch, Controls and connectors, Mode switch – Akai Multi Video Processor RMD-V3104U User Manual
Page 9: Reset button, Comb cable connector
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Signal name
FG.....................................................Frame Ground
TxD.............................. Transmitted Data
RxD....................................Received Data
RTS................................ Request to Send
CTS..................................... Cleat to Send
DSR................................. Data Set Ready
SG..................................................... Signal Ground
© Baud rate switch
Selects the baud rate for the RS-232C.
Baud rate switch (8-bit DIP switch)
Functions of bits
SIfit - Factory preset values
Switch No.
Function
ON
OFF
1
Parity
Yes
• Nb":::.--
2
Parity polarity
Even
■ ■ ■ ■
■
vuu
3
Character bits
Sbfts
7 bits
4
Stop bits
2 bits
1 bit
5
Baud rate setting
See table below.
6
y )Now)
Reserved
g (Note)
Reserved
(Note)
SW7 should always be set to OFF.
SW8 should always be set to ON.
Baud rates available with SWs 5 and 6
SWCi>5
sw(D-6
Baud rate (bps)
ON
ON
19,200
OFF
ON
9,600
ON
OFF
4JB8&
OFF
OFF
2,400
CONTROLS AND CONNECTORS
® MODE switch
Selects the video output mode.
MODE switch details
SW
No. *1
Output Mode Details
Frequency
mode
Output
mode
Standard/
double speed
*2
Middle cut
recovery
mode *3
0
NTSC
VBS,Y/C
Standard
OFF
1
RGB
2
Double speed
8
NTSC
VBS,Y/C
Standard
ON
9
RGB
A
Double speed
'1
I
The factory preset is "8".
*2
Standard............ Horizontal frequency 15.734 kHz
Double speed ... Horizontal frequency 31.468 kHz
(A multi-scan monitor such as the RMD-V4000V or
RMD-V5000Vis required to view video that is produced
by double speed signals.)
When viewing video that contains rapid movement,
there are times when the upper 2 screens do not follow
uniformly with the lower 2 screens. This phenomenon
is called "middle cutting" and can be alleviated by
setting the middle cut recovery mode to ON.
© Reset button
Press this button to reset the system. After the button
is pressed, the system enters the manual mode. In
manual mode, this unit can be controlled using the rear
panel switches, without using a computer.
When the reset button is pressed, this unit functions in
the modes selected by the rear panel switches.
^ COMB cable connector
Connects the interlock cable (cord with 6P mini-DIN
plugs) provided with the display.
9
<ARE1336>
En