Akai Multi Video Processor RMD-V3104U - Manual (Page 4)

PRECAUTIONS UPON USE A
> Ventilation (Install in a well-ventilated room)^
The rear panel is equipped with fans to prevent the
internal temperature from becoming too high. When
installing the unit, take special care not to block the
ventilation holes on the front, rear, and bottom panels.
If the ventilation holes are blocked, heat cannot escape
from inside of the unit and a fire hazard may result.
To install the unit in any of the following ways is not
recommended:
• Placing on one side
• Placing upside down
• Placing on a carpet or mattress
• Installing it in direct contact with the floor by removing
the feet (insulators)
• When installing the unit in directcontact with a wall,
placing on the rear panel, or in any other unusual
way, contact your dealer beforehand.
Avoid exposure to water ^
Do not place a vase, tropical fish basin or glass filled
with water on the unit. Should water fall into the unit,
turn off the power switch immediately and stop using
the unit. Remember to unplug the power cord from the
power outlet and have your dealer check or service the
unit
• Care of the product^
To clean this unit usually wiping with a soft, dry cloth
is sufficient If the unit is extremely dirty, use a soft
cloth soaked in a 5x to 6x solution of neutral detergent.
Wring out the excess liquid, clean the unit and then
wipe with a soft, dry cloth. Do not use alcohol, thinner,
benzine, or insecticide because these substances may
remove the surface printing or coating. Also do not
leave a rubber or vinyl product in contact with the unit
for extended periods of time, for this may damage the
cabinet When using a cloth treated with chemicals for
cleaning, read carefully the instructions that were
provided with the cloth.
Remember to unplug the power cord from the power
outlet before cleaning the unit
• Condensation
Condensation is one problem which may be faced in
the winter season. When the temperature in a room
installed with a multi projection unit rises suddenly,
condensation occurs on the lens, and as a result, the
system may not display its best performance. In such
cases, turn ON the power of the system after waiting
more an one hour. Another solution is to increase the
room temperature slowly.
* Connecting AV Equipment
To ensure reliability, this unit uses a BNC terminal for its
video input. When using the connection cable for the RCA
terminal, use the RCA—^BNC conversion plug.
Always use shielded type connection cables.
When connecting cables, be careful not to apply
excessive force.
Otherwise the connection terminals may be damaged.
INSTALLATION PRECAUTIONS
When this unit is stacked above or below other
components, or mounted in a rack, measures should
be taken to prevent the internal temperature of the unit
from rising too high.
• Transporting
In transporting the unit, care should betaken to prevent
the unit from being shocked, subjected to vibration, or
dropped. Also be careful that the unit is not subjected
to heat or moisture during transport.
• installation
This unit should be installed on a level and stable
surface. Do not use on an unstable surface and avoid
placing heavy objects on the unit.
Before moving the unit JL
When moving the unit after installation, set the power
switch to off, unplug the power cord from the power
outlet, and make sure to disconnect all cords from this
unit.
If the unit is moved without removing the cords, the
cords may be damaged and a fire hazard or electric
shock may result.
4
<ARE1336>
En