Akai Multi Video Processor RMD-V3104U - Manual (Page 8)

CONTROLS AND CONNECTORS
REAR PANEL
3
(p (?) ® ® ® ®
(T)
(8)(D (ja (Q)
È 1
mm
Ô
□ Si
3UT
i OUTPUT
R H/C8
) Pt (
ITOI IVBBf
I
/iSs
V GUn V OUTS "
[Ml E E
V OUT3 " V QU74 '
[M] E 0 ■Ï& E E
c.
r------->
© VBS/ Y/C switch
Selects whether the VBS (video signal) or Y/C signals
are input to the V IN (Video) input.
The factory preset is VBS (video signal).
© V.FIL (Vertical interpolation fitter) ON/OFF
switch
When the optional variable scan board (RMD-V3020) is
installed, use this switch to switch the vertical
interpolation filter ON/OFF. Set this switch to ON if the
top and bottom of the computer screen image cannot
be accommodated entirely by the screen.
The factory preset is set to ON.
© INPUT switch
Selects whether the V IN (Video) or OPTION input is
enlarged into 4 screens.
The factory preset is set to V IN.
* Always press the reset button after changing the
position of this switch.
© Remote control input connector
Connects the display's remote control unit.
(Adjustment or changes to the settings of the unît
cannot be accomplished with the remote control unit.)
® RS-232C switch
When performing adjustments from a computer, use
this switch to switch between this unit (MVP) and
display (DISPLAY).
8
<ARE1336>
En
© RS-232C connector
Connects RS-232C cable.
< RS-232C connector diagram >
RS-232C pin layout
< RS-232C connection diagram >
Use an RS-232C straight cable for connection.
<Externai computer>
RS-232C
<MVP unit>
RS-232C IN connector
* Pins 4, 5 and 6 are internally shorted.
Pins which are not shown in the diagram are not used.