Akai Multi Video Processor RMD-V3104U - Manual (Page 31)

MVP MANUAL
8. DEMO PATTERN SETTINGS AND CAUTIONS
The MVP does not have an RMD-V3216 type DEMO switch, but 2x2 enlarged screen automatic display is pos­
sible by reading the input selector switch (OPTION/V IN) when the power is turned on and executing the com­
mand corresponding to that setting.
Because of this, upon shipment from the factory command examples for displaying the MVP 2x2 enlarged
screens have been written into the demonstration switch No. 8 and No. 9 areas, which were user program areas
on the RMD-V3216.
Switch No. 8 contains the command example for displaying 2x2 enlarged screens for the OPTION input picture
(A input).
Switch No. 9 contains the command example for displaying 2x2 enlarged screens for the V IN input picture (C
input).
2x2 enlarged screens may not be displayed if the contents of demo No. 8 and demo No. 9 are replaced. If this
happens, reset the factory defaults.
The commands written into the set upon shipment from the factory and the procedure for writing the com­
mands are described below.
!
&NO011
&NO121
&NO212
&NO322
[8
W3
M11A22
]
[9
W3
M11C12
]
Start the command interpreter and input the following commands.
Matrix screen number setting . . . . . . . . . Set VOUT1 matrix coordinate to 11.
Matrix screen number setting. . . . . . Set VOUT2 matrix coordinate to 21.
Matrix screen number setting. . . . . . Set VOUT3 matrix coordinate to 12.
Matrix screen number setting. . . . . . Set VOUT4 matrix coordinate to 22.
Write in the command example for 2x2 enlargement of the A input to demonstration switch No.
8.
: Write in the command example for 2x2 enlargement of the C input to demonstration switch No. 9.
End.
The RM-V1000NU's internal MVP assembly (AWU1014-) uses slots A and B, but this set uses slots A and C.
Note that because of this the M command setting is different.
157