Ditch Witch UtiliGuard - Manual (Page 48)

UtiliGuard™ Series Operator’s Manual
Service - 47
As Needed
CMW
®
Transmitter Unit
Change Batteries
Use ten D-cell alkaline batteries or a Lithium-ion battery pack in transmitter.
1. Open battery cover.
2. Insert batteries as shown.
3. Close and tighten battery cover.
4. Check operation. If battery light is flashing
when unit is turned on, then one battery is
incorrectly installed or batteries are weak.
Battery cells inside may vent or rupture. Do not crush, do not heat or
incinerate, do not short circuit, do not dismantle, do not immerse in any liquid. Observe
charging instructions.
To help avoid injury, see battery manufacturer’s safety instructions.
IMPORTANT:
• Installing batteries backwards will
cause damage to batteries and
unit.
• Ensure that door is closed tightly.
• Do not mix new and used batteries.