Echelon i.LON 100 e2 Internet Server - Manual (Page 63)

i.LON 100 Internet Server User’s Guide 4-21
Delay Time Between Two
Retries
This option is not supported for LNS 3,
Service Pack 8, Update 1, and earlier.
This option is only available if Initiate LNS
Uplink When IP Address Changes is
checked. If the i.LON 100 attempts to inform
the xDriver of an IP address change and is not
successful, this is the amount of time before
another attempt is made.
Maximum Retry Time This option is not supported for LNS 3,
Service Pack 8, Update 1, and earlier.
This option is only available if Initiate LNS
Uplink When IP Address Changes is
checked. The amount of time, in minutes, for
which the i.LON 10 Ethernet Adapter will
attempt to inform the server of an IP address
change.
Initiate LNS Uplink
When Any Explicit
Message is Received
Set this option to initiate an uplink connection
from the i.LON 100 to the LNS Server whenever
an explicit message is sent to the host. If this
option is cleared, explicit messages for the host
will be held until a connection is established. By
default, this option is cleared.
Initiate Only When
Explicit Message Code is
in Range
Set this option to initiate an uplink connection
from the i.LON 100 to the LNS Server whenever
an explicit message with a message code within
the specified range is sent to the host. If this
option is cleared, explicit messages for the host
outside the specified range will be held until a
connection is established. By default, this option
is cleared.
Configuring Initiate LNS Uplink Properties
Set these options to determine when the i.LON 100 will attempt to initiate an
uplink connection to the LNS Server based on a network variable message for the
host. If an update is received that is not configured to establish an uplink
connection, the update will be held until a connection is established. By default,
all of these options are cleared (i.e. the i.LON 100 will never attempt to establish
an uplink connection as a result of a network variable message).
Click Submit to save the changes you have made to this Web page. Click Reset
to set all fields on this Web page back to the values they had when you opened
the page.
Configuring Time Settings
The i.LON 100 has a real-time clock. The time for this clock can be set manually
using the Time Web page or synchronized to an SNTP time server as described
in Configuring the Time Service, earlier in this chapter.
To view and set the time, hover your mouse cursor over Setup and select Time
from the dropdown menu. The Time Web page opens, as shown in the following
figure: