ENMET MX-32 - Manual (Page 15)

MX32 E NGUARD ENMET Corporation
11
4.3 Display Cycle of Channel measurements
C AUTION : The display and audio alarms operate independently. When an audio and visual alarm are active the
display does not automatically switch to the channel in alarm.
4.3.1 Display of No Measurements Mode
No measurements displayed.
By pressing both the – & + switches at the same time the display changes to no measurement display mode.
Example of the no
measurement Display:
- - - - -
ok
The display will remain in the no measurement mode
until the + & – switches are pressed at the same time to
change to the single channel display mode.
In the no measurement mode to display a channel manually press the + or – switch.
Examples of typical Display:
Press – to display
channel 1 for 1 minute
▲
0
co
Examples of typical Display:
Press + to display
channel 2 for 1 minute
▲
20.9
o2
After about 1 minute, the display returns to the no measurement display mode.
4.3.2 Display of a Single Channel Mode
The display will remain in the channel selected by pressing the + or – switch.
By pressing both the – & + switches at the same time a second time, the display changes to a single channel display mode.
By pressing the – switch, the display is manually changed to channel 1 and will continue to display channel 1 until the +
switch is pressed. By pressing the + switch, the display is manually changed to channel 2 and will continue to display
channel 2 until the – switch is pressed.
Examples of typical Display:
Press – to display
channel 1
▲
0 co
Press + to display
channel 2 ▲
20.9 o2
To return to the normal display mode press the – and + switches at the same time once more.