ENMET MX-32 - Manual (Page 17)

MX32 E NGUARD ENMET Corporation
13
5.1.3 MX32 C ONTROL Sequence of Maintenance Menus
See Table 4 for the sequence of maintenance menus and a description of their uses.
Press the + switch to move to the next menu (↓) or the – switch to move back to the previous menu (↑).
Table 4: MX32 Control Sequence of Maintenance Menus
Menu Description Display (flashing)
Access Code The key used to enter the maintenance
menus.
0000 cod
Enter Valid Code ↓ See section 5.1.1
Programming Used to program the parameters of a
measurement channel. See section 5.2
prg
Press + ↓ or – ↑
Calibration
* Factory set
Do Not use without
consulting
ENMET Corp
Used to check and make adjustments to
zero (clean air) and calibration gas.
See section 5.4
CAL
Press + ↓ or – ↑
Initialization
* Factory set
Do Not use without
consulting
ENMET Corp
Used to initialize the measurement curve
managed by the microprocessor with a
sensor. See section 5.3
ini
Press + ↓ or – ↑
Access Code Change Used to change the access code for
entering the maintenance menus.
See section 5.5 %
cod
Press – ↑
Buzzer Used to set the buzzer active or inactive.
See section 5.6
buz
* C AUTION : Do Not enter without first consulting ENMET Corporation.
Improper use will cause the MX32 to be Non-Functional
Use + to by pass this function.