Eurocom L390T Uno - Manual (Page 70)

BIOS Utilities
5 - 10 Advanced Menu
5
DFOROM (Robson) Support (Advanced Menu > SATA Mode Selection [AHCI]
This item will only be available if you have selected AHCI in SATA Mode Selec-
tion. The option should be enabled if you have included an optional Intel Turbo
Memory Module in your purchase configuration, or you want to support eSATA
port hot-swapping. You should then install the driver as per the instructions in
“Intel
Turbo Memory & Matrix Storage Setup and Driver Installation” on page 7 - 24 .
Reset Configuration Data (Advanced Menu)
This item is set to No as default. You can change the setting to Yes if you have in-
stalled a new add-on which has reconfigured the system, resulting in such a serious
system conflict that the operating system is unable to boot.
Boot-time Diagnostic Screen (Advanced Menu)
Use this menu item to enable/disable the Boot-time Diagnostic Screen (or POST)
screen.
Legacy OS Boot (Advanced Menu)
Enable this item to support only system boot from the Legacy OS (e.g Windows Vis-
ta). If disabled the system will attempt to boot from the EFI (Extensible Firmware
Interface) before the Legacy OS.

SATA Mode & eSata
Port
The eSATA port only
supports hot-swapping
if you have selected
AHCI mode in SATA
Mode Selection, and
enabled
DFOROM
(Robson) Support.