Eurocom L390T Uno User Manual
Page 85
Upgrading The Computer
Upgrading the System Memory (RAM) 6 - 9
6
3.
Gently pull the two release latches on the sides of the memory socket in the
direction indicated by the arrows (
&
)
in
Figure 6 - 9
.
4.
The RAM module will pop-up, and you can remove it.
5.
Pull the latches to release the second module if necessary.
6.
Insert a new module holding it at about a 30° angle and fit the connectors firmly
into the memory slot.
7.
The module’s pin alignment will allow it to only fit one way. Make sure the module
is seated as far into the slot as it will go. DO NOT FORCE the module; it should fit
without much pressure.
8.
Press the module in and down towards the mainboard until the slot levers click into
place to secure the module.
9.
Replace the module bay cover and screws.
10. Restart the computer to allow the BIOS to register the new memory configuration
as it starts up.
2
2
2
2
3
3
Contact Warning
Be careful not to touch
the metal pins on the
module’s connecting
edge. Even the cleanest
hands have oils which
can attract particles, and
degrade the module’s
performance.
Figure 6 - 9
RAM Module
Removal