Physical connections, Power input, Grounding screw – Hatteland Display 26 inch - HD 26T21 MMC (Widescreen) User Manual
Page 38
38
IND100133-45
Connection area of unit (illustration)
Physical Connections
- +
POWER INPUT:
Connect your DC power cable to the 2-pin Terminal Block 5.08 connector. The internal DC power module supports
24VDC. Please check specifications for your unit.
POWER INPUT:
The internal AC power module supports both 115VAC/60Hz and 230VAC/50Hz power input. Please check
specifications for your unit.
GROUNDING SCREW:
Please review “General Installation Chapter”, pt. 7 for more information.
Multi-power note: (For units supporting AC & DC input simultaneously)
The unit has a dual input power supply which will accept both AC and DC input. If both inputs are connected, the
unit will be powered by AC. If AC is disconnected it will automatically switch over to DC without affecting the operation
of the unit. This makes it possible to use AC power as primary power and a 24V battery as secondary power,
eliminating the need for expensive UPS systems.
Note: 24 inch unit used as example above, please review specifications for your actual model.
Reduce Cable Tension
To reduce tension of the cables you connect, secure them with
a cable tie to the available chassis hinges located near the
connectors. Note that the actual position of these hinges may
vary depending on the specific unit.
RGB/VGA Out
Grounding Screw
PS/2 Keyboard & Mouse In
RS-232 & RS-422/RS-485 COM
Power Inputs DC & AC
USB 1,2,3,4
2 x RJ45 Network
2 x Removable
Storage Trays
DVI-I/RGB Out
Mic In & Line Out
Expansion Area
for Optional Modules