Hatteland Display 26 inch - HD 26T21 MMC (Widescreen) - Manual (Page 57)

57
IND100129-139
All specifications are subject to change without prior notice!
PCA100294-1
Specifications - COM Module RS-232
1/2
This information may not, in whole or in part, be copied, photocopied,
reproduced, translated or reduced to any electronic medium or machine-
readable form without the prior written consent of Hatteland Display AS.
The products may not be copied or duplicated in any way.
Dimensions might be shown with or without decimals and indicated as mm [inches]. Tolerance on drawings is +/- 1mm. For accurate measurements, check relevant DWG fi le.
DATA SHEET
Hatteland Display AS, Åmsosen, N-5578 Nedre Vats, Norway
Tel: (+47) 4814 2200 - [email protected] - www.hatteland-display.com
Note: Product below for illustration only. Location of module and product size/design may differ. Connector/pinning remain the same.
*Configuration dependent, x = next available port number(s) in operating system.
Illustration and Pinning:
4 channel COM RS-232, DB9M COM Module
Manufacturer: Hatteland Display AS
Product: COM Module RS-232
Typenumber: PCA100294-1
Last Revised: 11 Nov 2014
Revision#: 09
Features:
The Hatteland Display COM modules provide the system with quad independent COM channels. The module is attached to the
motherboard via standard USB interface. Application software access the COM channels as standard COM devices, i.e. in the normal
case is there no requirements for additional software development. This module will mainly be integrated, electrical and mechanical,
in the final product such as Series X 12, 13, 15, 17, 19, 24 and 26 inch Panel Computers and selected Stand-alone Computers.
Description:
Internal USB to 4 channel x RS-232 non isolated
• Features
All channels have support for all RS-232 DB-9 signals
• Connector Standard RS-232 DB-9 male housing and pinning
• Data Rate 230kbps
• ESD Rating (IEC 1000-4-2 Air)
(RS-232 I/Os) ±15 kV
• ESD Rating (IEC 1000-4-2 Contact)
(RS-232 I/Os) ±8 kV
• Test and certi cate Hatteland Display standard,
(tested / type approved by the following classification societies):
IEC 60945 4th (EN 60945:2002), IACS E10, ClassNK - Nippon Kaiji Kyokai (Pending),
GL - Germanischer Lloyd, DNV - Det Norske Veritas, ABS - American Bureau of Shipping,
CCS - China Classification Society (Pending), BV - Bureau Veritas,
LRS - Lloyd’s Register of Shipping (Pending), EU RO MR - Mutual Recognition
• Supported Operating Systems (OS) Embedded Enterprise (WEE): Microsoft® Windows® XP Professional (Eng, SP3, SP2c),
Microsoft® Windows® Server 2003/2008/2008R2 (Eng), Microsoft® Windows®
2003/2008/2008R2 (Eng), Microsoft® Windows® 7 Professional/Ultimate (Eng, SP1).
Linux: openSUSE® 11.4, Fedora™ 15, Ubuntu® 10.04 LTS, Ubuntu® 12.04 LTS.
• Drivers For updates, please visit: http://www.ftdichip.com/Drivers/D2XX.htm
Note: Listed Operating Systems above are hardware/platform dependent. Please check datasheet for speci c unit if OS is supported.
- 4 independent channels (If a card is replaced most operating system will not change COM port number)
- Outputs are short circuits protected
1 2 3 4 5
6 7 8 9
4 Ports available in Operating System as:
COMx (A), COMx (B), COMx (C), COMx (D)*
B
A
D
C
PIN 01 DCD Data Carrier Detect
PIN 02 RxD Receive Data
PIN 03 TxD Transmit Data
PIN 04 DTR Data Terminal Ready
PIN 05 GND Signal Ground
PIN 06 DSR Data Set Ready
PIN 07 RTS Request To Send
PIN 08 CTS Clear To Send
PIN 09 RI Ring Indicator