Hatteland Display HM C01 (Rugged) - Manual (Page 21)

21
IND100210-2
General Installation Recommendations
Installation
Hard Drive (HDD) removal / replacement
Note: Areas of interest are marked in this section with circles and arrows in RED color. Please disconnect ALL
cables from the computer unit and HDD’s before proceeding!
Note: Illustration shows AC model. For DC models, the power supply must also be removed in order to gain easy access to the HDD. As of June
2011, DC illustration is pending for this page. Meanwhile, please visit http://www.hatteland-display.com/support for assistance if needed.
1: Unscrew 4 screws on each side of the PCI bracket.
Turn anti-clockwise using a Pozidriv #2 screwdriver.
2: Push each side of the bracket, one forward and one
backwards in a 45 degree rotation clockwise to slide it out
of the tracks. Then lift up the the bracket to remove it.
3: Unscrew 4 screws on each side holding the HDD
bracket at the bottom of the cabinet.
4: Lift the HDD bracket up and dismount the HDD from
the bracket itself by unscrewing its 4 screws (2 on each
side). Turn anti-clockwise using a Pozidriv #2 screwdriver.
Repeat the procedure backwards to finalize operation.