Hatteland Display HM C01 (Rugged) - Manual (Page 30)

Physical Connections
30
IND100133-35
LPT1 Parallel Port INPUT/OUTPUT:
Standard LPT1 Printer/Parallel (SPP/EPP/ECP) port using a D-SUB 25P Female connector. Fasten the cable to the
connector using the provided screws on the cable housing itself.
PS/2 Mouse and PS/2 Keyboard INPUTS:
Connect the PS/2 mouse cable to the PS/2 5P Connector (female) marked with MS. Connect the PS/2 keyboard cable
to the PS/2 5P Connector (female) marked with KB.
VGA/RGB OUTPUT:
Will output a signal from the computer for use with external display or monitor. Connects via a High Density D-SUB
15P Female connector. Fasten the cable to the connector using the provided screws on the cable housing itself.
Note: Signal Output will be disabled if additional graphics card is installed and present in one of the PCI/PCIe slots!
DVI-I OUT:
Connect your DVI cables to the DVI-I 24P Connectors (female) on the rear side of the unit. If possible, screw the DVI
cables to the connectors and make sure you don’t bend any of the pins inside the DVI cable connector.
Note: Signal Output will be disabled if additional graphics card is installed and present in one of the PCI/PCIe slots!
The DVI-I OUT connector can be configured as RGB OUT with the provided DVI-RGB adapter. However, the signal outputted is a direct clone of
RGB OUT signal. For true independent output, please connect a VGA/RGB cable to RGB OUT and a DVI cable to DVI-I OUT (without DVI-RGB
adapter) to achieve two different desktop outputs to two different displays or monitors. Please note that due to technical limitations, you can not
achieve 2 x VGA/RGB outputs simultaneously. If the adapter is used on DVI-I port, the VGA/RGB DB15F and adapter output will be sharing the
same signal, and if both outputs are used for external monitors, it could result in a unreliable and deteriorated signal and quality output.
USB3,4,5,6 INPUT/OUTPUT:
Supports any USB1.1 (12Mbps) or USB2.0 (480Mbps) compliant peripherals. Drivers for most USB devices are
usually included in operating system or on separate installation CD’s delivered with Third Party products. USB 1.1
devices will operate in USB 1.1 mode (12 Mbps).
Network INPUT/OUTPUT:
Supports 10/100/1000Mbps Ethernet (LAN). Suitable for twisted pair cables CAT.5E. Make sure the network cable
connector ”clicks” into the RJ-45 connector.
Audio INPUT/OUTPUT:
All connectors are 3.5” Jack Stereo. AC’97 audio support. Either function as Stereo Line In, Stereo Line Out and
Stereo MIC In or as 6-channel surround out where configuration is as follows:
Line In - Rear Sound L/R
Line Out - Front Sound L/R
Mic In - Center/Subwoofer Sound.
These settings can be modified within the audio driver software.