Imaxrc B6-TWINS - Manual (Page 10)

DISCHARGE OF NiCd/NiMH BATTERY
WARNING AND SAFETY NOTES DISCHARGE OF NiCd/NiMH BATTERY
Do not connect more than one battery pack to this charger at any one time.
To avoid short circuit between the charge lead always connect the charge cable to the
charger first, then connect the battery. Reverse the sequence when disconnecting.
Never attempt to charger or discharger the following types of batteries.
A battery pack which consists of different types of cells (including Different
manufacturers)
A battery that is already fully charged or just slightly discharged.
Non-rechargeable batteries (Explosion hazard).
Batteries that require a different charge technique from NiCd, NiMh, LiPo
or Gel cell(Pb, Lead acid).
A faulty or damaged battery.
A battery fitted with an integral charge circuit or a protection circuit.
Batteries installed in a device or which are electrically linked to other
components.
Batteries that are not expressly stated by the manufacturer to be suitable
for the currents the charger delivers during the charge process.
The screen shows the real-time status. Press BATT TYPE/STOP key to end the program. The
sound will emitted to indicates the end of program.
Set charge current on the left and the final voltage on the right. Range
of the charge current is 0.1-1.0A; range of final voltage is 0.1-25.0V.
Press START/ENTER key for more than 3 seconds to start the
program.
The screen indicates the discharging state. You can press
START/ENTER key to alter discharge current. Press START/ENTER
again to store the value. Press BATT TYPE/STOP key to stop
discharging. The emitted sound alerts the end of discharging.